2009 Nissan Rogue Fuse Box Diagram (2024)

FAQs

Where is the fuse interior fuse box? ›

Usually, you will find two fuse boxes in the car. One is located under the hood and the other is found in the dashboard or near the steering wheel.

Engine fuse boxes are typically situated near the battery. In this vehicle, the battery is on the driver's side, and there is a fuse box right above it with a black plastic cover to protect the fuses. On the passenger side, there is also a battery, and the fuse box is located nearby.

Its built into the Intelligent Power Distribution Module which is the fuse box under the hood. This same fuse box also has the fuse for the fuel pump and that is #57 which should be a 15 amp fuse.

It is located in the fuse panel on the driver's side of the instrument panel.

Locating the Fuse Box

In most cases, the main fuse box is situated under the hood, near the battery, while secondary panels can be found in the passenger compartment, often hidden behind a removable panel.

Finding Your Circuit Breaker or Fuse Box

Keep an eye out for a metal box, usually flush with the wall. The box will have a metal door to keep the breakers or fuses protected. Check your garage for the circuit breaker or fuse box. It might also be in a storage room, utility room, the basement, or a hallway.

The under-hood fuse box is located in the engine compartment next to the battery.

A switched fuse is one that only has power when the ignition is turned on, while a constant fuse always has power.

The most common sign of a bad fuel pump relay is an engine that cranks but doesn't start. A fuel pump relay will typically fail in the open position, preventing voltage from reaching the fuel pump. As a result, the engine will be starved of fuel and refuse to run.

Where is the fuse control panel? ›

The vehicle's fuses are located in two fuse boxes. The interior fuse box is underneath the steering column. The under-hood fuse box is in the engine compartment next to the battery. If something electrical in your vehicle stops working, the first thing you should check for is a blown fuse.

The box's surface may be flush with the surrounding wall or stick out a couple of inches. The box will have a metal door that must be opened to expose the fuses. Fuses lay flat on the outward-facing surface. They are round and screw into a socket in the box, much like a light bulb socket.

Well, there are a few telltale signs to look out for. Firstly, visually inspect the fuse and see if the filament inside is intact or broken. A blown fuse typically has a broken filament and a black or gray discoloration around it.